Foxflash Not Work with JTAG/BDM Cable Solution

Foxflash ECU Chip Tuning Tool can support JTAG/BDM mode for Denso ECUs reading and writing. Just need to open the ECU and connect it with the JTAG/BDM adapter. Sometimes, it cannot work normally. The possible cause is the ribbon cable is not correctly orientated. How to fix this problem if it appears?

Here is the solution:
Check the difference of JTAG/BDM cables below.

Remove the connector keyway to modify the cable

Then can plug the cable into foxflash ECU Programmer in correct orientation

The solution applies to the following ECUs supported by Foxflash:

BDM E JTAG MODES FOR:

BDM MPC 55x

BDM MPC 56x

BDM MC32 / ZC32

BDM HC12 / S12x

JTAG NEXUS MPC/SPC 56xx

JTAG NEXUS MPC 55xx

JTAG RENESAS

SH7055

SH7058

SH7059

SH7251

SH72543

SH72544

JTAG NEC 76F00xx

76F0038AGD

76F0038GD

76F0039AGD

76F0039GD

76F0040GD

76F0070

76F0085

DCM6.2A/C JTAG_BOOT

DCM6.2APJTAG_BOOT on the following ECU reference:

• Hyundai
• Audi
• Citroen
• Fiat
• Kia
• MAN
• Peugeot
• VW
• Toyota
• Ssangyong